Spring Sale up to 75% off ends Sunday

Curtain Pole & Rail Fitting Guide

Please note : This fitting guide is for a Allure Classic Curtain Pole

Tools required
curtain poles fitting guide drillbit

Drill bit

curtain poles fitting guide file

File

curtain poles fitting guide hacksaw

Hacksaw

curtain poles fitting guide pencil

Pencil

curtain poles fitting guide screw driver

Screw driver

curtain poles fitting guide spirit level

Spirit level

curtain poles fitting guide tape measure

Steel tape measure

curtain poles fitting guide step one

If you need to adjust the bracket projection, loosen the screws to adjust to the desired position. Once this has been done tighten the screws back up.

curtain poles fitting guide step two

Using a spirit level, position the brackets on the wall and mark the top line. We suggest 5 to 10cm above and to each side of the window recess; to ensure maximum coverage when the curtains are closed.

When the brackets are in the correct position, mark the mounting holes with a pencil. Drill these holes and attach the brackets in place.

curtain poles fitting guide step three

If the pole is 300cm or 360cm use the joining piece supplied. This is inserted half way into one pole, and the other pole is slid onto it. Next place the pole into the bracket and secure with the bracket screw.

curtain poles fitting guide step four

If required, use a hacksaw to trim an equal amount of each pole section. If there are any rough edges carefully use a file to smooth them out.

curtain poles fitting guide step five

If the pole is supplied with rings, place them as shown above. Do the same for eyelet curtains and tab top curtains.

curtain poles fitting guide step six

The final thing to do is double check all the brackets and finials are fully secured, before hanging the curtains.